Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 322 / 360

UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Unitized Transaxle Installation
Page 16-40 2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual
16
Unitized Transaxle Installation, Continued:
10. While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm lever
nut to 35 in-lb (4.0 N·m) (Figure 16-97, Page 16-40).
11. Install the key onto the input shaft (Figure 16-98, Page 16-41).
12. Position the driven clutch on the transaxle input shaft and install the washer (yellow side facing out) and
mounting bolt. Tighten the mounting bolt to 14 ft-lb (19.0 N·m) (Figure 16-98, Page 16-41).
13. Install the drive belt. See Section 17 – Torque Converter.
14. Remove the blocks from under the engine and roll the powertrain into position under the vehicle. Then
lift the front of the powertrain and place the snubber into the snubber bracket in the vehicle frame (Fig-
ure 16-99, Page 16-41).
15. With the floor jack under the transaxle, position the leaf springs in the front spring mounts and install
the grade eight bolts and locknuts. Tighten to 15 ft-lb (20.3 N·m) (Figure 16-100, Page 16-41).
∆ CAUTION
• Use only grade eight bolts for the front mounts of the leaf springs.
Figure 16-95 Accelerator Cable Bracket
Figure 16-96 Governor Cable Bracket Figure 16-97 Governor Arm
BRACKET
1. Install the governor arm
on the governor shaft.
2. Turn shaft counterclockwise.
4. Tighten the
retaining nut.
3. Pull governor arm rearward.