Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 255 / 360

FUEL SYSTEM Carburetor
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 14-5
14
• Fuel lines (from fuel tank to filter to pump to filter to carburetor). See Fuel Lines on page 14-27.
• Exhaust system (for restrictions). See Section 15 – Exhaust System.
If the carburetor floods or leaks fuel at the float bowl gasket or carburetor vent tube, the fuel inlet valve could
be worn or dirty. Another cause of this condition may be a damaged float that has filled with fuel and sinks.
For elevations above 3000 feet, main jets other than standard operate more effectively. The following chart
lists the elevation ratings for various jet sizes. No adjustment is required for the pilot jet. If the vehicle idles
roughly, turn the pilot air screw (Figure 14-3, Page 14-3) out until the vehicle idles smoothly.
MAIN JET ELEVATION/SIZE CHART
CHANGING THE MAIN JET
Read DANGER and WARNING on page 14-1.
1. Remove the carburetor (Figure 14-6, Page 14-6).
1.1. Access engine compartment.
1.2. Turn fuel shut-off valve on gas tank to the closed (OFF) position.
1.3. Loosen the intake air hose clamp (22) and disconnect the intake air hose (23) at the carburetor
end only.
1.4. Remove the governor cable cotter pin (25) and clevis pin (24) (carburetor end only).
1.5. Disconnect the carburetor vent line (14).
1.6. Disconnect the fuel supply line (26) at the carburetor end only. Temporarily plug the end of the fuel
line to prevent fuel leakage.
1.7. Remove the carburetor retaining nuts (19), intake pipe (17), and carburetor (12). See following
NOTE.
NOTE: Note the orientation of the gasket (16), between the carburetor intake pipe (17) and the carburetor
body (12) so that it can be replaced in the same orientation (Figure 14-6, Page 14-6).
When removing the carburetor body, the throttle return spring (11) must be disconnected. Note its
proper orientation so that it can be replaced with the same orientation.
The carburetor must be kept upright during removal.
2. Position the carburetor with the drain screw (11) over a catch basin (Figure 14-7, Page 14-7).
ALTITUDE
FE350 ENGINE
MAIN JET SIZE
0-3000 ft.
(0-914.4 m)
85
3000-5000 ft.
(914.4-1524 m)
82
500-8000 ft.
(1524-2438.4 m)
80
8000-10,000 ft.
(2438.4-3048 m)
78
10,000 ft. and over
(3048 m and over)
75