Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 175 / 360

ELECTRICAL COMPONENTS Voltage Regulator
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 12-13
12
5. Position a pry bar (13) between the top of the starter/generator mounting bracket (2) and the underside
of the starter/generator by passing the pry bar under the exhaust header.
6. While holding the pry bar, measure the belt tension using a Krikit
®
gauge (1) (available at NAPA
®
Auto
Parts stores), or equivalent. Proper tension for a new starter/generator belt should be 75 ft-lb (101.7
N·m) or for an existing belt, 45 ft-lb (61 N·m) (Figure 12-15, Page 12-12).
7. While maintaining the tension, tighten the adjustment nut (12) to 12 ft-lb (16.3 N·m). Tighten the two pivot
bolts (5) and hex nuts (7) to 23 ft-lb (31.2 N·m) (Figure 12-14, Page 12-12). See following CAUTION.
∆ CAUTION
• Remove pry bar before starting engine.
8. Connect battery cables, positive cable first and tighten the terminals to 20 ft-lb (27.1 N·m). Coat termi-
nals with Battery Protector Spray (CCI 1014305).
VOLTAGE REGULATOR
Read DANGER and WARNING on page 12-1.
Testing the Voltage Regulator
See Test Procedure 12, Section 11, Page 11-32.
Voltage Regulator Removal
1. Disconnect the battery cables, negative cable (–) first (Figure 12-1, Page 12-2).
2. Remove the electrical component box cover.
3. Disconnect the voltage regulator red wire (1) at the large post on the solenoid, the yellow wire (4) at the
bullet connector, and the black wire (7) from the wire harness and at the battery frame ground (Figure
12-16, Page 12-13).
4. Remove the voltage regulator mounting screw (8) and remove the voltage regulator (9).
Figure 12-16 Voltage Regulator
8
9
1
TO SOLENOID
4
TO BULLET
CONNECTOR
7
TO BATTERY
FRAME GROUND
TO KILL LIMIT
SWITCH
ELECTRICAL
COMPONENT BOX