Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 169 / 360

ELECTRICAL COMPONENTS Starter/Generator
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 12-7
12
Bearing Removal
1. Place the wedge attachment tool (CCI 1012812) between the bearing and the armature. Make sure the
wedge attachment tool is supporting the inner race of the bearing. If a press is not available, secure a
bearing puller (CCI 1012811) to the wedge attachment tool and pull the bearing off of the end of the
armature shaft. Support the armature so that it will not drop when the bearing is removed (Figure 12-
10, Page 12-7).
2. Discard the bearings.
3. Slide the bearing retainer (32) off of the output end of the shaft (Figure 12-8, Page 12-6).
Field Coil Removal
1. Remove the retaining nut from each field coil terminal and slide the insulator out of the slots in the
housing. Remove the four pole piece screws from the housing. Remove the four pole pieces from
inside the housing. Remove the field coils from the inside of the housing (Figure 12-11, Page 12-8).
See following NOTE.
Figure 12-9 Bearing Play Inspection
Figure 12-10 Bearing Removal
A
B
USE A
1/2 INCH
SOCKET
OR PIPE
PRESS RAM
USE A 1/2 INCH
SOCKET OR PIPE
SUPPORT
INNER RACE
OF BEARING
PRESS ON
ARMATURE
SHAFT
WEDGE
ATTACHMENT
TOOL
BEARING
PULLER
TOOL
WEDGE
ATTACHMENT
TOOL
NOTE: BEARING IS
SECTIONED FOR CLARITY