Club Car DS Villager 4, Руководство по техническому обслуживанию и ремонту

Страница: 395 / 510

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS Fuel Gauge/Hour Meter
19
4. Remove the screws (2).
5. Remove the brake light relay.
BRAKE LIGHT RELAY INSTALLATION
1. Install the brake light relay (1) on the instrument panel (Figure 19-31, Page 19-28) .
2. Install the screws (2).
3. Connect the wires to the brake light relay terminals (Figure 19-32, Page 19-29) .
Pin Description Wire Color
1 Blue
2 Red
4 Black
6 Green
Figure 19-32 Brake Light Relay Terminals
4. Install the instrument panel.
5. Connect the battery and spark plug wire.
FUEL GAUGE/HOUR METER
GENERAL INFORMATION
With the key switch in the OFF position, the fuel gauge field is blank; however, the hour meter field is always ON.
When the key switch is turned to ON, the fuel gauge field activates. The fuel gauge initially registers full before
indicating the actual fuel level.
The hour meter displays the number of hours of use in increments of 0.1 (one tenth) hour, but does not record
additional time unless the key switch is in the ON position and the engine is on. When recording, the hourglass icon
on the left blinks.
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual Page 19-29