Club Car DS Villager 4, Руководство по техническому обслуживанию и ремонту

Страница: 350 / 510

18
Test Procedures
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM
TEST PROCEDURE 9 – Transaxle Limit Switch
See General Warnings on page 1-2.
NOTE: This is a continuity test.
This switch is located on the transaxle. A black/pink wire, a red wire, and a gray wire are connected to this limit
switch with a 3-pin connector.
1. If necessary, see Testing Basics.
2. Disconnect battery and spark plug wire.
3. At the transaxle, disconnect transaxle limit switch three-wire lead from main wire harness.
4. Make sure that the cam lobe on the shift lever is pressing the transaxle limit switch as the Forward/Neutral/Reverse
control (FNR) is being shifted.
4.1. If the transaxle limit switch does not make an audible click as it is pressed, check for wear on the cam
lobe and replace shift lever if necessary.
5. Check the following terminals for no continuity with the lever released and continuity with the lever engaged
(Figure 18-7, Page 18-16) :
PROBE BETWEEN LOCATIONS TEST RESULT
With lever released: No continuity
Between terminal 1 “COM” (black/pink wire) and terminal 2 “NO” (gray
wire)
With lever pressed: Continuity
With lever released: Continuity
Between terminal 1 “COM” (black/pink wire) and terminal 3 “NC” (red
wire)
With lever pressed: No continuity
3028
Figure 18-7 Transaxle Limit Switch Test
6. If transaxle limit switch does not work as stated in previous step, replace the transaxle limit switch.
Page 18-16 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual