Club Car Carryall 300 2021, Руководство по техническому обслуживанию и ремонту

Страница: 469 / 596

GASOLINE VEHICLE - TRANSAXLE Shifter Cable
24
5. Loosen jam nuts (1) securing shifter cable (2) to FNR/accelerator cable bracket (3) (Figure 24-16, Page 24-15) .
Then, remove bowtie clip (3) to disconnect shifter cable end (4) from transaxle shift lever (5).
6. Cut wire ties securing shifter cable to chassis.
7. Make note of cable routing, then remove shifter cable from vehicle.
2
3
1
4
4
2
3
5
1
3064
Figure 24-15 Shifter Cable at FNR Handle
3065
Figure 24-16 Shifter Cable at Transaxle
SHIFTER CABLE INSTALLATION
1. Install shifter cable (2), routing it exactly as it was originally, from instrument panel to transaxle.
2. Place rear of cable (2) in FNR/accelerator cable bracket with a jam nut (1) on each side of bracket (Figure 24-16,
Page 24-15) . Tighten jam nuts (1) to 22 ft·lb (29.8 N·m).
3. Hook shifter cable end (4) into transaxle shift lever (5) and secure with bowtie clip (3).
4. Feed front of cable (2) through its mounting hole and push the plastic anchor into hole until tangs (4) snap
into place
(Figure 24-15, Page 24-15) .
5. Snap cable end socket (1) onto stud (3) of Forward/Reverse shifter handle.
6. Secure shifter cable along chassis with wire ties.
7. Connect battery and spark plug wire. See Connect the Battery- Gasoline Vehicles on page 1-4.
SHIFTER CABLE ADJUSTMENT
Cable is properly adjusted when both the Forward/Neutral/Reverse control (FNR) at instrument panel and shift lever on
transaxle are in the NEUTRAL position at the same time.
To adjust, the jam nuts (6) at the FNR/accelerator cable bracket must be loosened and moved forward or backward as
required
(Figure 24-16, Page 24-15) . Tighten jam nuts (6) to 22 ft·lb (29.8 N·m).
2021 Carryall 300 Maintenance and Service Manual Page 24-15