Club Car Carryall 295 SE, Руководство по техническому обслуживанию и ремонту

Страница: 59 / 456

SECTION 5 – ACCELERATOR AND BRAKE PEDAL ASSEMBLIES
5
DANGER
• See General Warnings, Section 1, Page 1-2.
WARNING
• See General Warnings, Section 1, Page 1-2.
ACCELERATOR PEDAL – THROUGH EARLY 2010 MODEL YEAR
See General Warnings, Section 1, Page 1-2.
ACCELERATOR PEDAL REMOVAL – THROUGH EARLY 2010 MODEL YEAR
1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
3. Disconnect the cable strain relief from the pedal bracket.
4. Disconnect the Z-shaped end (1) of the accelerator cable from the pedal (Figure 5-1, Page 5-1) .
1885
Figure 5-1 Z-Shaped Cable End – Gasoline Vehicles
5. Remove the pedal assembly bolts and locknuts that secure the pedal assembly to the frame.
6. Slide out and twist the pedal to remove the pedal assembly from the frame.
7. Inspect the pedal bushings for wear and replace pedal assembly if worn.
8. Inspect the pedal and return spring hub bushings for excessive side-to-side movement. Replace the pedal
assembly if either or both show signs of excessive wear.
2008-2012 All-Wheel Drive Maintenance and Service Manual Page 5-1