Club Car Carryall 295 SE, Руководство по техническому обслуживанию и ремонту

Страница: 53 / 456

BODY AND TRIM Cargo Bed – Electric Lift
4
4
1 6
6
2
2
3
1
5
2475
Figure 4-6 Driver Seat Belt – Homologated Models
SEAT BELT INSTALLATION – HOMOLOGATED MODELS
1. Driver seat: Install the seat belt buckle assembly and coiled seat belt assembly to the driver seat as shown
with hardware previously removed except for the lock nut (Figure 4-6, Page 4-13) . Use a new lock nut and
tighten to 33 ft-lb (44.7 N·m).
2. Passenger seat: Install the center seat belt buckle assembly to the seat belt bracket with hardware previously
removed except for the lock nut (Figure 4-5, Page 4-12) . Use a new lock nut and tighten to 33 ft-lb (44.7 N·m).
Secure the coiled seat belt assembly on the outside of the ROPS seat support with the shoulder bolt and a
new lock nut
(Figure 4-4, Page 4-12) . Orient the assembly with the tang end pointed up slightly and tighten
the new lock nut to 33 ft-lb (44.7 N·m).
CARGO BED – ELECTRIC LIFT
See General Warnings, Section 1, Page 1-2.
TESTING THE BED LIFT MOTOR
Gasoline Vehicles: See Test Procedure 35 – Bed Lift Motor on page 11-38.
Diesel Vehicles: See Test Procedure 36 – Bed Lift Motor on page 12-43.
BED LIFT MOTOR REMOVAL
1. Make sure the key switch is OFF and the Forward/Reverse handle is in the NEUTRAL position. Remove the
key. Chock the wheels.
2. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
3. With the bed in the down position, working from under the vehicle, disconnect the two wires from the connectors
at the electric bed lift motor.
2008-2012 All-Wheel Drive Maintenance and Service Manual Page 4-13