Club Car Carryall 295 SE, Руководство по техническому обслуживанию и ремонту

Страница: 430 / 456

19
Cylinders HYDRAULIC ATTACHMENT SYSTEM
CYLINDER BUSHINGS (IF EQUIPPED)
Removal and Installation
WARNING
• Wear safety glasses to prevent eye injury when any of the following conditions exist:
– Fluids are under pressure.
– Flying debris or loose material is present.
– Engine is running.
– Tools are being used.
1. Remove bushing(s) (1) (Figure 19-73, Page 19-36) from the base end of the hydraulic cylinder, one bushing
on each side of cylinder.
2. Apply LOCTITE 271 (Red) to the bushings (2) before installing them into the cylinder (Figure 19-74, Page 19-36) .
1
2
2289
Figure 19-73 Remove Bushings From Base
2290
Figure 19-74 Apply LOCTITE and Install Bushings Into
Base
3. Remove the two bushing(s) (1) (Figure 19-75, Page 19-37) from the rod end of the hydraulic cylinder.
4. Apply LOCTITE 271 (Red) to the bushings (2) before installing them into the cylinder (Figure 19-76, Page 19-37) .
Page 19-36 2008-2012 All-Wheel Drive Maintenance and Service Manual