Club Car Carryall 295 SE, Руководство по техническому обслуживанию и ремонту

Страница: 375 / 456

DRIVETRAIN COMPONENTS Rear Axle – Starting 2012 Model Year
17
REAR AXLE – STARTING 2012 MODEL YEAR
REAR AXLE REMOVAL
1. Disconnect battery and spark plug wire(s) (gasoline vehicles only) . See Disconnecting the Battery –
Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Loosen the lug nuts on both rear wheels.
3. Lift and support the rear of vehicle and remove the wheel(s). See Lifting The Vehicle on page 3-9.
4. Detach hydraulic brake hose where anchored to rear axle at four places shown (Figure 17-16, Page 17-11) .
5. Remove the hex-head bolts securing the brake calipers to axle tubes (Figure 17-16, Page 17-11) . Discard bolts.
6. Remove brake calipers from rear axle and temporarily hang them from the chassis with a piece of wire. See
following CAUTION.
CAUTION
• Do not kink, twist, or damage the hydraulic brake lines.
2502
Figure 17-16 Rear Brake Caliper and Hose Removal – 4 Link
7. Position the floor jack under the differential and raise the jack just enough to support the axle (Figure 17-14,
Page 17-9) .
8. Detach rear shock absorbers from axle. See Rear Coil-Over Shock Absorber – Starting 2012 Model Year
on page 9-4.
9. Remove the roll pin from the differential pinion shaft and rear driveshaft universal coupling. See following NOTE.
2008-2012 All-Wheel Drive Maintenance and Service Manual Page 17-11