Club Car Carryall 295 SE, Руководство по техническому обслуживанию и ремонту

Страница: 142 / 456

10
Engine Oil PERIODIC MAINTENANCE
203
Figure 10-14 Add Engine Oil – Gasoline Vehicles
212
Figure 10-15 Add Engine Oil – Diesel Vehicles
Engine Oil Filling
1. Add engine oil (Figure 10-14 or Figure 10-15) . With filter change, the engine requires the following amounts:
– Kawasaki gasoline engines: 1 qt. and 19 oz. (1.5 L) of oil per change.
– Kubota diesel engines: 3 qt. (2.8 L) of oil per change.
2. Refer to oil viscosity guidelines for selection of oil grade (Figure 10-16 or Figure 10-17) . See following
CAUTION.
CAUTION
• Do not exceed recommended oil capacity. Doing so will decrease engine performance or result in
damage to the engine.
3. Install the oil filler cap.
4. Connect battery and spark plug (Gas only) wires. See Connecting the Battery – Gasoline/Diesel Vehicle
on page 1-4.
5. With the Forward/Reverse handle in the NEUTRAL position, start and run the engine for three minutes and check
for leaks. Observe both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If the filter
leaks, tighten an additional 1/4 turn and retest. If the oil drain plug leaks, re-torque and retest.
NOTE: Wait a few minutes after turning off the engine before removing the dipstick.
6. Remove the dipstick and check the engine oil as a final step. Replace the dipstick.
OIL VISCOSITY
Choose the viscosity according to the temperature as shown in the appropriate oil viscosity chart (Figure 10-16
or Figure 10-17) . See following NOTE.
NOTE: Use engine oil with API classification SJ for gasoline engines and CF for diesel engines.
Page 10-12 2008-2012 All-Wheel Drive Maintenance and Service Manual