Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 218 / 312

FE400 ENGINE Crankcase
Page 13-4 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
13
Engine Removal, Continued:
4. Remove muffler. See Muffler Removal, Section 15, Page 15-1.
5. Remove engine mounting hardware (items 1, 2, 5 and 6) (Figure 13-1, Page 13-4) .
6. Lift engine from the mounting plate.
7. Remove crankcase oil drain plug and filler tube. Tip the engine slightly to allow all of the oil to drain from
the crankcase. Dispose of engine oil properly.
CRANKCASE COVER REMOVAL
1. Remove yellow jumper wire (11) from cord connector (12) (Figure 13-2, Page 13-5) .
2. Remove nuts and clamps at two-ended bolts (1 and 2) (Figure 13-3, Page 13-5) .
3. Remove eight bolts (3) and remove the crankcase cover (4). See following NOTE.
NOTE: If the crankcase cover sticks, tap lightly with a plastic mallet on alternate sides near the dowel pins
(5)
(Figure 13-3, Page 13-5) .
4. Remove the crankcase cover gasket completely. It may stick to the flanged surface of the crankcase.
Figure 13-1 Engine Mounting Plate - with MC012C-BS00 Transaxle
ClubCar
ClubCar
TYPICAL
2 PLACES
TYPICAL
4 PLACES
TYPICAL
4 PLACES
3
1
4
5
2
TYPICAL
2 PLACES
6