STEERING AND FRONT SUSPENSION
Front Suspension
7
FRONT SUSPENSION
See General Warning on page 1-1.
LUBRICATION
Five grease fittings are provided (one in each spindle housing, one in the ball joint on each end of the tie rod, and one
in the ball joint of the steering drag link). Lubricate these fittings at the recommended interval with the proper lubricant.
See Periodic Lubrication Schedules on page 10-6.
CAUTION
• To ensure proper lubrication of the front suspension and steering linkages, raise front of vehicle
to lubricate. See General Warning on page 1-1.
WHEEL ALIGNMENT
Wheel alignment is limited to equalizing the camber angle of each front wheel and adjusting toe-in of the front wheels.
There is also a drag link adjustment to equalize the turning radius in both directions.
page 7-5. See following NOTE.
NOTE:
Prior to making any front suspension adjustments, inspect components for wear and damage and repair or
replace as necessary.
Camber Adjustment
1.
Check each front wheel with a framing square. At the floor (or ground), there should be an equal amount of space
between each tire and the framing square
2.
Loosen, but do not remove, the four nuts (32) that secure the leaf spring (6) to the bottom spring plate (29)
See also Figure 7-16, Page 7-13.
A
A
B
A
1
2
1. Proper Camber Adjustment 2. Improper Camber Adjustment
32
8
7
Figure 7-15
Check Camber
Figure 7-16
Adjust Camber
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Page 7-13
Содержание CARRYALL 252 2007
