28
Transaxle
TRANSAXLE (TYPE G): ELECTRIC VEHICLES
Figure 28-8
Disconnect Shocks
Figure 28-9
Detach Spring From Shackles
6.
Disconnect the shock absorbers from their lower mounts
.
7.
Disconnect the four motor wires. Use two wrenches to prevent the post from turning.
8.
With a floor jack supporting the transaxle, remove lower spring shackle nuts and bolts. Rotate shackles up
and away from springs
.
9.
If a chain hoist was used to raise the vehicle, lift the vehicle high enough to permit easy access and clearance
for removal of the motor. If a floor jack was used to raise the vehicle, lower the transaxle enough to permit
easy access and clearance for removal of the motor.
10. Remove the three motor mounting bolts
and the motor positioning bolt
mounting the motor to the transaxle.
See following CAUTION.
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft. Fingers may get
pinched when motor disengages.
1
2
3
4
1. Motor Mounting Bolts
2. Input Pinion Gear
3. Intermediate Gear Assembly
4. Differential Gear Case
Figure 28-10
Detach Axle From Leaf Springs
Figure 28-11
Motor Mounting Bolts
11. Carefully remove the motor from the transaxle. Slide the motor away from the transaxle until the motor spline
becomes disengaged from the input shaft, then lift motor out.
See preceding WARNING.
Page 28-6
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Содержание CARRYALL 252 2007
