Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 48 / 536

5
Accelerator Pedal – Gasoline Vehicles ACCELERATOR AND BRAKE PEDAL GROUP
26
22
21
21
19
18
20
24
4
5
1
25
17
8
9
13
12
11
7
6
5
14
15
16
G
O
24
25
17
10
23
Figure 5-5 Accelerator Pedal – Gasoline Vehicles
ACCELERATOR PEDAL INSTALLATION – GASOLINE VEHICLES
1. If the accelerator pivot rod supports were replaced, position the supports (21) on the vehicle frame and install the
four bolts (22), flat washers (19), and lock nuts (18). Finger-tighten nuts at this time
(Figure 5-5, Page 5-6) .
2. Insert the lower end of the accelerator pedal (1) through the floorboard and install the accelerator pivot rod (6)
through the uppermost hole in the pedal.
3. Install the plastic spacer (20) on the pivot rod (6).
4. Insert the pivot rod through the pivot rod supports on the vehicle frame.
5. Tighten the four bolts (22) attaching the pivot rod supports to the frame to 75 in-lb (8.5 N·m).
6. Install the bolt (4), two washers (5), and a new lock nut (7) through the lower hole in the pedal and through the
pivot rod. Finger-tighten nut at this time.
Page 5-6 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual