Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту, Страница: 470 / 536

24
Solid State Speed Controller
ELECTRICAL COMPONENTS: ELEC-
TRIC VEHICLES
SOLID STATE SPEED CONTROLLER
See General Warning on page 1-1.
TESTING THE SOLID STATE SPEED CONTROLLER
See Test Procedure 5 – A1 and A2 Motor Voltage on page 22-15.
SPEED CONTROLLER REMOVAL
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2. Remove the speed controller cover. See Removing the Speed Controller Cover on page 24-8.
3. Disconnect all wires and multi-pin connectors from the speed controller.
4. Remove the four bolts (1) that hold the speed controller (2) to the component mounting plate and remove
the controller from the vehicle.
1
2
Figure 24-9 Speed Controller
SPEED CONTROLLER INSTALLATION
1. Install the four bolts (1) that hold the speed controller (2) to the component mounting plate and tighten to 60
in-lb (6.8 N·m)
(Figure 24-9, Page 24-12) .
2. Using the wiring diagram, install the multi-pin connectors and all wires as illustrated. See Wiring Diagrams,
Section 22, Page 22-2. Tighten bolts (3) to 9 ft-lb (12.2 N·m) (Figure 24-9, Page 24-12) .
3. Install the speed controller cover. See Installing the Speed Controller Cover on page 24-8.
4. Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
5. Place the Tow/Run switch in the RUN position.
6. Inspect the vehicle for proper operation:
– Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch is in the
FORWARD position.
Page 24-12 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual