Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 306 / 536

17
Carburetor S10 FE 350 FUEL SYSTEM
NOTE: Make sure the fuel bowl gasket (9) remains properly seated in the carburetor body when the fuel bowl
is removed (Figure 17-4, Page 17-4) .
During normal operation, the fuel bowl retains the float pivot pin (6). Make sure that the float pivot pin does not
fall out of the carburetor body after the fuel bowl is removed.
6. Remove the main jet (8) from the carburetor body and discard it (Figure 17-4, Page 17-4) . See following NOTE.
NOTE: Make sure the fuel nozzle (7) does not fall out of the carburetor body after removal of the main jet. This is best
accomplished by positioning the carburetor upside down during main jet removal (Figure 17-4, Page 17-4) .
1
2
3
4
5
7
8
6
9
11
12
10
537
Figure 17-4 Carburetor Components
7. Select the proper size main jet. See Main Jet Elevation/Size Chart on page 17-2. Check the size designation
on the jet to make sure it is the correct part.
8. Install the new main jet and tighten it to 12 in-lb (1.4 N·m). See following CAUTION and NOTE.
CAUTION
• Do not remove the valve/spring assembly from the float assembly. Doing so will damage the spring.
NOTE: Inspect the main jet nozzle (7), and pilot jet (4) to ensure they are free from contamination (Figure 17-4,
Page 17-4) . Replace any part that is clogged with contamination. Replace the float if it is damaged, or
if the float valve is damaged or worn. Examine the float valve/spring assembly to make sure the spring is
installed correctly
(Figure 17-5, Page 17-5) .
9. Install the fuel bowl. Make sure that it is positioned properly by aligning the marks applied in step 4. See
following CAUTION.
Page 17-4 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual