Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 160 / 536

11
Test Procedures
TROUBLESHOOTING AND ELECTRICAL SYSTEM:
KEY-START WITH NEUTRAL REV GAS VEHICLE
2. Inspect wires at light bulb socket. Make sure wires are securely fastened to the contacts inside socket.
3. Remove the wire harness from the headlight (Figure 11-42, Page 11-38) .
4. Using a multimeter set to 20 volts DC, place the black (–) probe of multimeter into the black wire terminal of the
wire harness. Place the red (+) probe into the blue wire terminal.
5. Pull the light switch to the ON position. If the multimeter reads approximately 12 volts, replace the bulb.
6. If there is no voltage reading at the wire harness, check continuity of the 16-gauge blue wire from the headlight
to the light switch. Using a multimeter set to 20 volts DC, attach using an alligator clip, the black (–) probe of
multimeter onto the negative battery terminal and place the red (+) probe into the blue wire terminal of the wire
harness. If multimeter reading is approximately 12 volts, the blue wire has continuity.
7. Check continuity of the 16-gauge black wire from the headlight to the ground terminal. Using a multimeter set
to 20 volts DC, place the black (–) probe of multimeter into the black wire terminal of the wire harness and
attach using an alligator clip, the red (+) probe onto the positive battery terminal. If the multimeter reading is
approximately 12 volts, the black wire has continuity.
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM
200nA
MAX
1000 ---
750V
FUSED
485
Figure 11-42 Check Voltage to Headlight Socket
Page 11-38 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual