Rear Fender Installation
2007 Gasoline Utility Vehicle Owner’s Manual
Page 39
4. Make sure fender is correctly aligned in the vehicle by placing the outer fender rib to the outside of the
upper side panel, and as far forward as possible, leaving no gap between the fender and side panel
(Figure 23)
.
5. Drill three 5/16-inch holes through the fender: two through the outside holes in the front mounting
bracket, and one through the slotted hole in the top mounting bracket
(Figure 23)
.
6. Loosely install bolts (1), large flat washers (2), small flat washers (4), and locknuts (3) in the front mount-
ing bracket holes.
7. Install bolt (1), large flat washer (2), small flat washer (4) and locknut (3) in the top mounting bracket hole
as shown
(Figure 23)
.
8. Tighten mounting hardware at both front mounting bracket holes, then both top mounting bracket holes,
to 35 in-lb (4.0 N·m).
9. Repeat steps 3-8 for the other rear fender.
10. Lower cargo bed.
Figure 23 Drill Additional Mounting Holes
Fro
nt of
Ve
hicle
DRIVER SIDE SHOWN
2
4
3
2
1
3
4
1
Before drilling holes,
move fender as far
forward as possible.
Do not allow any gap
between fender and
side panel.
UPPER
SIDE PANEL
TOP MOUNTING BRACKET
FRONT MOUNTING
BRACKET
Fender rib to
outside of
side panel
Содержание CARRYALL 252 2007
