Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 408 / 436

19
Cylinders HYDRAULIC ATTACHMENT SYSTEM
2275
Figure 19-59 Install Wiper Seal
2276
Figure 19-60 Install Back-up Washer
9. Install the O-ring next to the back-up ring as shown (Figure 19-61, Page 19-34) .
10. If a seal was removed from the head, use the following procedure to install a new seal.
11. Install the guide with a pilot and an adapter, if they are required, on the head (Figure 19-62, Page 19-34) .
12. Install the seal on the head using the guide (Figure 19-62, Page 19-34) . See following CAUTION.
CAUTION
• Do not turn (roll) the seal as you install it. Damage to the seal may result.
2277
Figure 19-61 Install O-ring on Head
2278
Figure 19-62 Install Seal
13. Use a ring compressor to compress the seal to the correct size (Figure 19-63, Page 19-35) . Leave the tool over
the Teflon seal for five minutes.
14. Install the head on the rod (Figure 19-64, Page 19-35) .
15. Note piston type and install according to the following criteria:
15.1. For cylinders with a cushioned piston, install the piston on the rod with the tapered end first (toward the
head) (Figure 19-65, Page 19-35) .
15.2. For all other cylinders, install the cushion sleeve (if so equipped) and piston on the rod (Figure 19-66,
Page 19-35) .
Page 19-34 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual