Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 391 / 436

HYDRAULIC ATTACHMENT SYSTEM Electrical
19
3. Remove four screws securing control box cover/joystick assembly and pull assembly out enough to access
the relays.
See Joystick Removal on page 19-11.
4. Ensure the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
5. Locate and pull or pry the relay out of the multi-pin connector to remove (Figure 19-22, Page 19-11) .
Float Relay 1 and 2 Installation
1. Insert the relay into the multi-pin connector. See following NOTE.
NOTE: The relay contacts are keyed to ensure that the relay can only be installed in the correct orientation. If the
relay is not easy to insert, rotate the relay until the correct contact orientation is obtained.
2. Install control box cover/joystick assembly and secure with the four screws.
3. Connect battery. See Side-Post Battery: Connecting the Battery – Gasoline/Diesel Vehicles on page 1-4.
See Top-Post Battery: Connecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
Testing the Accessory Relay
30
85 86
87a
87
1
2
4
3
1. Red
2. Black (Negative [–)
3. Orange (Positive [+])
4. Red
2244
Figure 19-28 Accessory Relay Location
2245
Figure 19-29 Accessory Relay Wiring and Testing
1. Test for continuity between terminal 85 (black wire) and terminal 86 (orange wire) (Figure 19-29, Page 19-17) .
2. Test for no continuity between terminals 87 and 30 (red wires) (Figure 19-29, Page 19-17) .
3. Apply 12 volts with the positive lead connected to terminal 86 and the negative lead connected to terminal 85.
The relay should click and show continuity between terminals 87 and 30 (red wires).
Accessory Relay Removal
1. Remove driver seat.
2. Disconnect battery. See Side-Post Battery: Disconnecting the Battery – Gasoline/Diesel Vehicles on page
1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
3. Remove the electrical component cover.
4. Ensure the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
5. Locate and pull or pry the accessory relay out of the multi-pin connector to remove (Figure 19-28, Page 19-17) .
Accessory Relay Installation
1. Insert the relay into the multi-pin connector. See following NOTE.
NOTE: The relay contacts are keyed to ensure that the relay can only be installed in the correct orientation. If the
relay is not easy to insert, rotate the relay until the correct contact orientation is obtained.
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual Page 19-17