Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 334 / 436

16
Engine Control Linkages
DIESEL ENGINE, MUFFLER, FUEL SYSTEM,
AND CLUTCHES
2185
Figure 16-16 Tachometer For Engine RPM
2186
Figure 16-17 Clean Metal Fuel Line
2187
Figure 16-18 Diesel Probe Fuel Line Clamp On Engine
2188
Figure 16-19 Diesel Probe Battery Cable Clamp
3. Secure the fuel line probe clamp to the clean area of the fuel injector line (Figure 16-18, Page 16-20) .
4. Secure the negative (–) line clamp to the negative (–) battery post (Figure 16-19, Page 16-20) .
5. Secure the diesel probe to the tachometer (Figure 16-16, Page 16-20) . See following NOTE.
NOTE: It may be necessary to cut the wire attached to the adjustment screws. The manufacturer recommends that a
new wire be secured to the screws after new RPM settings are established.
6. Turn the key switch to start and run the engine at idle. Measure the RPM with the tachometer and diesel probe
attachment. Note the RPM reading. The correct idle RPM setting for this diesel engine is 1300 RPM ±25.
7. Turn the key switch OFF. Turn the low-speed adjustment screw 1/4 turn clockwise to raise the RPM, or
counterclockwise to lower the RPM
(Figure 16-20, Page 16-21) .
8. Turn the key switch to start the engine and allow it to idle. Measure the RPM. Repeat steps 6 and 7 until the idle
RPM is correct.
See following NOTE.
Page 16-20 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual