Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 299 / 436

GASOLINE ENGINE, MUFFLER, FUEL SYSTEM,
AND CLUTCHES Engine Control Linkages
15
1
3
2
4
3
2162
Figure 15-16 Choke Cable on Engine
2163
Figure 15-17 Choke Cable Through Front Cover
Choke Cable Installation
1. Secure a new choke cable to the nylon cord outside of the instrument panel. At the engine compartment, pull the
nylon cord until the choke cable reaches the engine.
2. Push the choke cable ferrule into the instrument panel hole so the tines engage behind the panel.
3. Secure the choke cable to the frame with the plastic retention clips.
4. Install the engine front cover (4) and secure with pan-head screws tightened to 54 in-lb (6 N·m) (Figure 15-17,
Page 15-23) .
5. Feed the Z-shaped cable end (2) of the choke cable through the engine front cover (Figure 15-16, Page 15-23) .
6. Push the cable sheath strain relief (3) into the engine front cover (4) until it snaps into place (Figure 15-17,
Page 15-23) .
7. Insert and secure the Z-shaped end of the choke cable (2) to the choke lever on the side of the carburetor
(Figure 15-16, Page 15-23) .
8. Secure the choke cable return spring (1) to the hook on the choke lever.
9. Install the engine top cover and tighten the four bolts to 35 in-lb (4 N·m).
10. Install the center seat plate.
11. Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery – Gasoline/Diesel
Vehicles on page 1-4.
See Top-Post Battery: Connecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
12. Install the center seat plate (bucket seat vehicles only).
13. Install seat(s).
14. Lower and secure the hood.
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual Page 15-23