15
Engine Control Linkages
GASOLINE ENGINE, MUFFLER, FUEL
SYSTEM, AND CLUTCHES
4
7
8
5
3
6
2362
Figure 15-14
Accelerator Cable at Pedal (Z-Shaped Cable
End and Anchor)
2160
Figure 15-15
Accelerator Cable at Engine
Accelerator Cable Installation
NOTE:
When the accelerator cable is replaced, the high-speed RPM must be adjusted.
1.
Installation is reverse of removal procedure.
2.
Connect battery and spark plug wire(s).
See Side-Post Battery: Connecting the Battery – Gasoline/Diesel
CHOKE CABLE
Choke Cable Removal
1.
Disconnect battery and spark plug wire(s).
See Side-Post Battery: Disconnecting the Battery –
Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2.
Remove seat(s).
3.
Remove the center seat plate (bucket seat vehicles only).
4.
Remove the engine top cover.
5.
Remove the choke cable return spring (1) from the hook on the choke lever
6.
Remove the Z-shaped cable end (2) from the choke lever on the carburetor.
7.
Remove the engine front cover (4)
8.
Remove the cable sheath strain relief (3) from the engine front cover
9.
Raise the hood.
10.
Compress the choke ferrule tines on the back side of the instrument panel. Pull the cable up from the engine
compartment and remove the cable.
See following NOTE.
NOTE:
Tie a heavy nylon cord to the cable end before removing the cable. When removing the cable, allow the
cord to travel from the engine compartment up through the instrument panel hole. Use the cord to route
the cable during installation.
Page 15-22
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
Содержание Carryall 1500 2016
