Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 167 / 436

TROUBLESHOOTING AND ELECTRICAL
SYSTEM: GASOLINE VEHICLES Test Procedures
11
2092
Figure 11-19 Neutral Switch – Neutral Position
2094
Figure 11-20 Neutral Switch – Reverse Position
4. Check for continuity on the switch contacts with the Forward/Reverse handle in the NEUTRAL position (Figure
11-19, Page 11-25) . The multimeter should indicate continuity.
5. Check for continuity on the switch contacts with the Forward/Reverse handle in the REVERSE position (Figure
11-20, Page 11-25) . The multimeter should indicate no continuity.
6. If any of the continuity readings are incorrect, replace the neutral switch. See Neutral Switch Removal on
page 13-2.
TEST PROCEDURE 16 – Wire Continuity
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery –
Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. To test a wire for continuity, disconnect either end from the electrical component to which it is attached.
3. Set the multimeter to 200 ohms and place the red (+) probe on the terminal at one end of the wire. Place the
black (–) probe on the other terminal end of the wire. The reading should indicate continuity. If the reading is
incorrect, repair or replace the wire.
See following NOTE.
NOTE: When checking continuity of wires in the wire harness, observe the polarity of diodes. Testing continuity of
certain wires will require the appropriate diode test procedure. See Test Procedure 9 – Wire Harness
Diodes on page 11-19.
TEST PROCEDURE 17 – Front Differential Limit Switch
See General Warnings, Section 1, Page 1-2.
NOTE: Keep the battery connected during this test procedure.
The front differential limit switch is located under the hood where the accelerator pedal mounts to the chassis.
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual Page 11-25