Club Car CARRYALL 1 2000, Руководство по техническому обслуживанию и ремонту

Страница: 61 / 136

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 5-11
5
Adjust the Actuator Lever, Continued:
6.3. Remove two screws (20) and detach the potentiometer housing cover (Figure 5-17, Page 5-11) .
Slightly loosen the bolt (9) (Figure 5-18, Page 5-11) attaching the actuator lever to the adjustment
bracket.
6.4. Rotate the actuator lever (25) on the pivot rod weldment (6) clockwise until the red LED is illumi-
nated (limit switch clicks ON). Then rotate the actuator lever (25) on the pivot rod weldment (6)
counterclockwise just to the point at which the red LED on the CTM goes out (limit switch clicks
off)
(Figure 5-15, Page 5-10) .
6.5. Tighten the actuator lever bolt (9) (Figure 5-18, Page 5-11) to 75 in-lb (8.5 N·m). This step
sequence ensures the solenoid will not engage with the accelerator pedal in the fully upright posi-
tion and with the park brake set. If the red LED is illuminated at this point, repeat step 6.4.
6.6. Meter should indicate 3.38 to 3.42 volts. If not, proceed to step 6.7. If so, proceed to step 6.9.
6.7. Loosen the potentiometer adjustment lock nut (Figure 5-19, Page 5-12) .
6.8. Using a potentiometer adjustment tool or very small flat blade screwdriver (electronics type), turn
the potentiometer adjustment screw until the CTM reads from 3.38 to 3.42 volts (Figure 5-20,
Page 5-12) . Then tighten the potentiometer locknut to 5 in-lb (.6 N·m).
6.9. Again loosen actuator lever bolt and rotate actuator lever counterclockwise until red LED goes off.
Figure 5-16 Adjust Micro Break Point
Figure 5-17 Remove Potentiometer Cover Figure 5-18 Loosen Bolt
PARK
STOP
GO
4-5/8 INCHES
MICRO B
REAK PO
INT
REPOSITION ACCELERATOR
PEDAL ADJUSTMENT TOOL SO THAT
"MICRO BREAK POINT" IS TOWARD
FLOORBOARD. DEPRESS THE
ACCELERATOR PEDAL UNTIL A
PEDAL HEIGHT OF 4-5/8 INCHES
IS REACHED
READS MICRO
BREAK POINT
USE A RUBBER STRAP
TO HOLD PEDAL IN
DEPRESSED POSITION
PARK
GO
STOP
MICRO BRE
AK POINT
USE A 1/4 INCH
SOCKET OR A NUT
DRIVER TO REMOVE
TWO SCREWS (20)
REMOVE POTENTIOMETER
HOUSING COVER
20
SLIGHTLY LOOSEN BOLT (9) WITH
A 7/16 INCH DEEP WELL SOCKET
9