Club Car 2002 Pioneer 1200, Руководство пользователя

Страница: 24 / 44

Storage
Page 22 2002 Pioneer 1200 Gasoline Vehicle Owner’s Manual
STORAGE
Read DANGER and WARNING on page 7.
∆
DANGER
• Never attempt to drain gasoline when the engine is hot or while it is running.
• Be sure to clean up any spilled gasoline before operating the vehicle.
• Store gasoline in an approved gasoline container only. Store in a well-ventilated area away
from sparks, open flames, heaters, or heat sources.
• Keep gasoline out of the reach of children.
• Do not siphon gasoline from the vehicle.
∆
WARNING
• Turn the key switch OFF, remove the key, and leave the Forward/Reverse handle in the
NEUTRAL position during storage. This is to prevent unintentionally starting the vehicle or a
fire hazard.
• Turn fuel shut-off valve to closed (OFF) position (Figure 12, Page 23).
• Do not attempt to charge frozen batteries or batteries with bulged cases. Discard the battery.
Frozen batteries can explode.
∆
CAUTION
• Batteries in a low state of charge will freeze at low temperatures.
PREPARING THE VEHICLE FOR EXTENDED STORAGE
1. Unload the vehicle so that tires are supporting only the weight of the vehicle.
2. Batteries should be clean and free of corrosion. Wash tops and terminals of batteries with a solution of
baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse solution off bat-
teries. Do not allow this solution to enter the batteries. Be sure terminals are tight. Let the terminals dry
and then coat them with Battery Terminal Protector Spray (CCI 1014305).
3. Store vehicle in a cool, dry place. This will minimize battery self-discharge. If the battery appears to be
weak, have it charged by a trained technician. Use an automotive-type 12-volt battery charger rated at
10 amps or less.
4. Drain carburetor and seal the fuel tank.
4.1. Place the Forward/Reverse handle in the NEUTRAL position. Turn the fuel shut-off valve to the
closed (OFF) position (Figure 12, Page 23) and run the engine until fuel remaining in the carbu-
retor and fuel lines is depleted and the engine stalls.
4.2. Loosen, but do not remove, the carburetor drain screw and drain fuel remaining in bowl into a small
clean container, then pour the fuel from the container into vehicle fuel tank. Tighten the carburetor
drain screw.
4.3. Fill fuel tank to about 1 inch (2.5 cm) from top of fuel tank and, following manufacturer’s directions,
add a commercially available fuel stabilizer (such as Sta-Bil
®
).
4.4. Disconnect fuel vent line from fuel tank vent nipple.
4.5. Plug the fuel tank vent nipple so that it is air tight. We recommend using a slip-on vinyl cap.