C S V-1 5 4 5 M A N U A L
SenseVision MST Hub USB Type C to DisplayPor t™ 1.2 dual monitor
www.club-3d.com
The DP Multi-Stream Hub requires the following:
Computer that supports DisplayPort™ 1.2 with multi-stream support*
• Microsoft Windows:
- Windows 7 SP1 (32-bit or 64-bit editions)
- Windows 8 (32-bit or 64-bit editions)
*Use of the DP Multi-Stream Hub with a computer that does not meet this
specification is not supported.
*The Reset key only use when the PC does not recognize the HUB device.
Troubleshooting
Here are the steps to solve possible problems.
Scenario: No video on any downstream monitor connected:
1. Check the LED to make sure the hub has power. Use only the power adapter that was provided
with the hub.
2. Check that each downstream monitor is powered on.
3.Check the DisplayPort™ cable to be sure it is connected to the computer and hub.
Use only the DisplayPort™ cable that was provided with the hub for the connection to the computer.
4. Check the computer or graphics card user manual to confirm that DisplayPort™ 1.2 and a
multi-stream video signal are supported.
5. Check the Windows Display Control Panel to confirm that the downstream monitors attached
to the hub have been detected and enabled.
Resolutions / Refresh Rate
Recommended system requirements
Quick start guide
