
-1-
-2-
-3-
1.
General
This heater is especially for use on Ponds.
it is very simple to install and use the Heater, But the basic safety
Precautions should always be followed.
2.
Installation
The Pond Heater should be connected to the outlet of the pond
pump making sure the water is flowing in the direction shown on
the Pond Heater. This Heater must be installed horizontally.
Dimensions and of the pond heater Refer to (
Fig.1
)
3.
Heater installation
(
Fig.3
)
Separate the connection nut, And join the feed pipe to the heater
making sure the Sealing ring is in the correct position and screw
up the compression nut (make sure not to over tighten).
Loop pipework to perventing Heater unit from draining (
Fig.6
).
4.
Electrical Connection
4.1 The electrical installation should have an all poles disconnection
System with contact opening at least 3mm.
4.2 For continued protection against possible electric shock this
Pond Heater unit is to be mounted in accordance with
the instillation instructions.
4.3 For the protection of the system this heating unit should be wired
on to a Residual Current device (RCD) with a rated tripping current
not exceeding 30mA. The supply cable should comply with EMC
standards.
!
This item must not be disposed of into the domestic
waste. Please ensure it is disposed in an authorized place
for recycling of with electrical and electronic appliances.
Resources, And make sure the product is disposed in an
environmental friendly way.
Cloverleaf
Pond Heater
Operating Instructions
IMPORTANT : Notice Please Read
Before Installing and Power on !
1. DANGER :RISK OF ELECTRIC SHOCK
Connect only to a circuit protected by a RCD Unit.
2. Grounding is required.
3. This product must be installed by a qualified electrician.
4. Do not cover the heater when in use.
5. When using for the first time , Ensure all pipe work is full of water
and primed before turning the power on.
7. Children should be supervised to ensure not to adjust
the heater settings.
8. Do not switch on if there is a possibility that water inside
the heater is not frozen
9. IP45 Rated
10. Save these instructions.
4.4 The electrical installation Must be carried out by a qualified
electrician Following strict standards.
4.5 Be sure that the earth cable connection is correctly made.
4.6 Wires serving as equipotential bonding conductors shall have a
cross section area between 2.5mm and 6mm.
4.7 After the unit has been wired up turn on the power and press
the reset button of the GFCI, (Ground Fault Circuit Interrupter)
the GFCI works and cut the power, Then repress the reset button
on the GFCI to reconnect the power. If the above operations do
not work check the GFCI connections, turn off the power supply
until the problem is solved and “RESET” Appears.
CAUTION
: In order to avoid a hazard due to inadvertent resetting of
the thermal cut out, this Pond heater must NOT be powered
through an external switching device, such as a timer, Or connected
to a power supply circuit that is regularly switched
ON and OFF.
W
ARNING
!
Thermal cut-out
(Manually resettable)
Located under
screw cap.
Fig.4
www.cloverleaf.uk.net
Cloverleaf Industries Ltd
King Street, High Ongar, Essex, CM5 9NP
t:+44(0)1277366002/ f: +44(0)1277366004