www.vcloudpoint.com
- 2 -
Hardware setup:
1) Install the hard drive into the NAS, and secure it with screws.
2) Connect the NAS to the switch using Ethernet cable.
3) Connect the NAS to the power and finish the setup.
First Time Installation:
4) Power the NAS device on, and wait for 1 to 2 minutes.
5) Open the browser with any computer in the same LAN, view
http://find.synology.com
or the IP address of the NAS device to enter
the Web Assistant page.
6) After entering the Web Assistant page, click
Install Now
and confirm
the hard disk mode (select the default system) to download the
Synology DSM system from internet, follow the prompts to complete
the installation.
7) After installing the system, create the administrator account and
customize DSM update and maintenance; leave QuickConnect settings
as default.
8) After initial installation is complete, enter the system;this storage
solution is used only as a private disk for vCloudPoint users, other
plug-ins is not required for installation.
NAS System Quick Setup:
9) Open the
control panel
file sharing
shared folders
and
edit
homes
folder.
10) Select: (
Hide this shared folder in “My Network Places”; Hide
subfolders and files from users without permission; Enable
recycle bin
)
Cancel: (
Restrict access to administrator only
)
11)
Confirm
the settings of the
homes
folder.
12) Apply the same steps to rest of the
Shared Folders
.
13) Open
Connectivity
Network
Network Interface
, select
LAN
and
Edit:
14)
IPv4
Use manual configuration
, set static IP address for the NAS
device;
15)
IPv6
Select
Off
to turn off the
IPv6
, then
confirm
the settings.
16) Open
Connectivity
network
traffic control
, select the top right
corner of the
LAN
Click
Edit
select
All ports
, Set the
bandwidth
settings
. The default NAS LAN transmission bandwidth is 1Gbps. But
we recommend to set to 20000KB/s, the largest 40000KB/s. If
bandwidth limitation is not set, users will use up all the bandwidth
while transferring files.
