Bose
Two Channel Equalisation Module: Installation Guide
2
16-07-02 V2
3 Installation
Instructions
1. Switch off the power and remove the mains lead.
2. Remove the top panel from the unit.
3. Remove both jumpers from the connector(s) you are to use (See previous page for details).
4. Configure the relevant 65Hz filter (See previous page for details).
5. There will be two M3 screws through the PCB, one either side of the connector. Remove these
screws & retain them. In their place screw in the two 25mm M3 hex spacers provided.
6. Connect the Bose
equalisation module onto the relevant PCB connector. Making sure that the
module is in the orientation shown in the diagrams below:
Top Down View of Bose
Equalisation Module Orientation in a CX-A6
(Same orientation as CX-A4)
Ribbon Cable Orientation (Side View)
6. Line the holes of the Bose
equalisation module up with the hex spacers and fit the two M3
screws (removed earlier)
7. Replace the top panel.
Bose
is a registered trademark of The Bose Corporation
Cloud Electronics Limited 140 Staniforth Road Sheffield S9 3HF England
Tel44(0) 114 244 7051 Fax +44(0) 114 242 5462 E-mail: [email protected]
