E
N
G
L
I
S
H
3
C
H
A
R
G
E
D
POWER LEVEL
F
E
T
E
S
T
C
H
A
R
G
I
N
G
Figure 2. Test Button, Charging and
Charged LED’s
E
F
POWER LEVEL
T
E
S
T
C
H
A
R
G
I
N
G
C
H
A
R
G
E
D
1. With J2000 turned off hook the red
clamp to the weak battery's positive
(+) terminal, hook he black clamp to
a metal part of the vehicle's frame.
2. Push button (below) to turn J200-on.
3. Turn the vehicle ignition. Once vehicle
starts. turn the J2000 off by
pushing button again.
4. Disconnect J2000 clamps from
battery
OFF
ON
Figure 3. Indicator Panel (J2000)
RECHARGE THE
PORTABLE POWER
SOURCE
Note:
There are two ways to charge
the portable power source.
The first method is automatic
charging with the provided
wall charger (preferred). The
second is through the dc
power jack through the power
extension cord. The second
method is not automatic and
requires watching because the
portable power source could
be damaged due to
overcharging.
1.
With the wall charger. The portable
power source is automatically
charged using the wall charger. A
CHARGING JACK (may be found in
the rear or on a side of your
portable power source) is
connected through a smart circuit
board to the portable power source
making recharging automatic.
Recharging takes approximately 4
to 6 hours for each light that does
not come on when the test button is
pressed. Overcharging is not a
problem when using the wall
charger and the portable power
source can be left connected to the
wall charger indefinitely.
PORTABLE POWER
SOURCE
FEATURES
•
Provides plenty of power for
starting vehicles. More than
enough to start most cars. May
also be used in DEEP CYCLE
applications.
•
The portable power source will
power most 12 Vdc accessories
equipped with a male cigar lighter
plug. The dc outlet has automatic
overload protection.
•
Test switch and LED lights. State
of the art circuit.
INFORMATION TO USER
Changes or modifications to the portable
power source, by the user, that are not
expressly approved by the party
responsible for radio frequency emission
levels from the portable power source,
could cause an undesireable amount of
radio frequency energy to be emitted.
Such action could void the user’s
authority to use the portable power
source.
SAFETY FEATURES
•
Safety storage holsters prevent
accidental sparking of clamps and
rotate 90° for easy clamp removal.
•
Cable grooves lock the cables for
clean storage. (No unsightly
dangling wires).
•
The portable power source
contains the latest technology with
its 12 volt sealed non spillable
battery. The portable power source
may be stored in any position.
RECHARGING
PROCEDURES
When new, your portable power source
should be charged for a minimum of 30
hours, unless all the power level lights
and the charged light come on when the
test button is pressed.
842-270-000 Portable Power Source En, Sp, Fr, Pg, Du.p65
3/12/01, 10:14 AM
3
