11
Electrical Motor and Switch (3)
Motor with 1.07 HP (800W). The motor is designed to operate on 115-120 volts, 60 Hz,
single phase electrical circuits. Use a circuit with a 15 Amp circuit breaker for best
performance. The ON-OFF switch also serves as emergency stop.
Tilting Table (4)
The cutting table tilts to 45 ° for making miter cuts. To tilt the cutting table loosen the two
screws on the side and pivoting the table. The CTC701 has a built in gauge for precise
angle adjustments.
Guide-a-cut (5)
The guide-a-cut can be adjusted to the desired cutting width. It is locked using two
screws. The guide-a-cut is also adjustable for miter cuts.
Blade Guard (6)
The pivoting blade guard is designed to accept a 7” (177mm) diameter blade and offers
maximum operator protection and increased visibility of the work piece. The guard is
attached to the frame.
