2
1
Align the holes on the backrest with the holes
on the chair frame and insert a 2" pan head bolt
through each of the hollow tubes on the chair
frame. Place one washer on the nut side each of the
2" bolts from the pervious step. Secure the frame
and backrest by tightening the K-Nuts with a Phillips
screwdriver and a 7/16" wrench.
Gently rest the chair frame on a clean protected
area. Slide the chair backrest into the hollow
tubes in the chair frame.
3
(For all models)
Remove the arm post(s) from
the chair frame and attach the elbow pad/rest
to the arm post using pan head bolts and
washers.
For models with padded elbow pad use two (2) 2" pan
head bolts and two (2) washers to attach each elbow
pad.
For models with ClintonClean
™
arms use two (2) 1-3/4"
pan head bolts and two (2) washers to attach each
elbow pad.
Be sure to properly align the pad and post as shown below.
(NOTE: The padded elbow rest is engineered for right or left flip
arms. For a left flip arm, (from the front) use the set of holes on
the right side of the inverted pad. Conversely, for a right hand
flip arm use the holes on the left side when the pad is inverted.
(Holes should face the front of the arm.)
ClintonClean™ elbow rests are universal and hove only one set
of holes.
LEFT FLIP ARM, ELBOW PAD
APPLICATION
RIGHT OR LEFT FLIP ARM, CLINTONCLEAN
™
ELBOW
REST APPLICATION
