CLIMIA CTK 240, Руководство по эксплуатации

Страница: 8 / 24

8
CLIMIA
nozzle into the condensate
container below either continuously
or only during the defrosting
phases.
A float is installed inside the
condensate container. In the event
that the container is full, the float
will activate a microswitch which
will switch off dehumidification
mode.
The units switch off and the
“container full” indicator light on
the control panel illuminates.
This extinguishes again when
the empty condensate container
is re-inserted.
The units then restart.
In unattended continuous operation
with an external condensate
connection, the condensate that
occurs is drained continuously via
a hose connection. The units then
start.
In unattended continuous operation
with an external condensate
connection, the condensate that
occurs is drained continuously via
a hose connection.
Recirculating fan
Condensate
container
Condenser
Evaporator
Condensate trap
Compressor
Moist room air
Dehumidified
room air
Fig. 1 Schematic depiction of the workings of the air dehumidifier
7.0 Unit description
In dehumidification mode, one of
the “Fan stage” indicator lights on
the control panel illuminates.
The fan extracts the moist room air
through the intake grill with filter,
evaporator and the condenser
behind.
Heat is removed from the room air
on the cold evaporator . The air is
then cooled to below dew point.
The water vapour contained in
the room air is then deposited
as condensate or rime on the
evaporator fins.
On the condenser (heat exchanger),
the cold and dehumidified air is
warmed up again and discharged
back into the room via the outlet
grill with a temperature increase of
around 5 - 10 °C above the room
temperature.
The processed, dry air then re-mixes
with the room air.
Continuous circulation of the room
air through the unit gradually
reduces the relative humidity (% RH)
in the room to the desired humidity
level.
Depending on the room air
temperature and the relative
humidity, condensed water will drip
into the condensate trap and then
through the integrated discharge
The units have been designed for
universal and straightforward air
dehumidification.
Their compact dimensions allow the
unit to be transported and set up
with ease.
The units operate in accordance
with the condensation principle and
are equipped with a hermetically
sealed refrigerant system, heat gas
defrosting, low-noise and low-
maintenance fan and connection
cable with plug.
The fully automatic control, the
variable hygrostat, the condensate
container with integrated overflow
protection and the connection
nozzle for condensate drainage
guarantee fault-free continuous
operation.
The units conform to the
fundamental health and safety
requirements of the appropriate EU
stipulations.
The units are dependable and offer
ease of operation.
The units are used in all locations,
where dry air s a must and where
economic consequential damage
(such as that caused by mould)
must be prevented.
The units may be used for the
drying and dehumidification of
areas such as:
• Living rooms, bedrooms, shower
rooms or cellar rooms
• Laundry rooms, weekend homes,
caravans
• Warehouses, archives,
laboratories
• Bathrooms, wash rooms and
changing rooms etc.
• Basements, storage rooms
Operating sequence
The units are switched on and off by
the power key.