ClimbTech SWY100N-MTU, Руководство по эксплуатации и инструкция

Страница: 7 / 12

STRAIGHT LOOP INSERT
See Straight Loop Insert Manual for anchorage casting instructions.
Internal Tooth
Lock Washer
WARNING: Do not install if insert was knocked over during installation.
Mega Swivel must mount fl ush to surface when fastened with the
proper torque.
Torque Range:
70 to 80 ft-lbs
Orange
Housing
Plastic Bolt to
be removed
5/8”-11x3.25”
Hex Cap Bolt *
Note: Ensure internal threads are
thoroughly coated with NLGI 2
multi-purpose lithium grease
( meeting Sinopec specification
Q / SH 303 242 - 2007 or equivalent ) .
1. Strip decking to expose the Straight Loop Insert.
2. Ensure that anchorage was properly installed. Orange indicator should be fl ush with
concrete surface, and at least 9” from any edge or corner. Concrete should be at least
6” thick and cured to a minimum of 3000 psi.
3. Remove plastic bolt and o-ring using 1/2” allen wrench.
4. Save plastic bolt and o-ring to re-insert into Straight Loop Insert when not in use.
5. Insert bolt and washer through Mega Swivel and into the threaded
hole of the Straight Loop Insert.
6. To fasten Mega Swivel, tighten bolt* to 70-80 ft-lbs using torque wrench.