The ASCII list about the product is shown as below.
ASCII Command
Serial port protocal: Baud rate
：
115200 (default), Data bits: 8bit, Stop bits:1, Check bit: 0
TCP/IP protocol port: 8000. The x, y, z, XXX are parameter.
RS-232 Command
Function description
Feedback
System Setting
r type!
Get device model
HDP-MXB42AP
r status!
Get device current status
Get the unit all status:
power, in/out connection,
video/audio crosspoint, edid,
scaler,hdcp, network status
r fw version!
Get Firmware version
MCU BOOT: V1.00.01
MCU APP : V1.10.05
Output Setting
r hdmi y scaler ! Get hdmi output y port output mode y=0~2(0=all) hdmi output 1 set to bypass
mode
s hdmi y hdcp z! set hdmi output y port hdcp status y=0~2(0=all)
z=0~1(1=on,0=off)
hdmi out 1 hdcp on
r link in x!
Get the connection status of the x input port
，
x=0~4(0=all)
HDMI IN1: connect
r link out y!
Get the connection status of the y output port
,
y=0~2(0=all)
HDMI OUT1: connect
s reset!
Reset to factory defaults
Reset to factory defaults
System Initializing...
Initialization Finished!
s power z!
power on/off the device,z=0~1(z=0 power off,
z=1 power on)
Power on
System Initializing...
Initialization Finished!
power off
r power!
get current power state
power on /power off
s reboot!
reboot the device
Reboot…
System Initializing...
Initialization Finished!
s in x av out y!
Set input x to output y
，
x=1~4
，
y=0~2(0=all)
input 1 -> output 2
r av out y!
Get output y signal status y=0~2(0=all)
input 1 -> output 1
input 2 -> output 2
s hdmi y stream z ! Set hdmi output y stream on/off, y=0~2(0=all)
z=0~1(0:disable,1:enable)
Enable HDMI out1 stream
Disable HDMI out1 stream
r hdmi y stream! Get hdmi output y stream status, y=0~2(0=all)
Enable HDMI out1 stream
s hdmi y scaler z! Set hdmi output y port output mode
,
y=0~2(0=all),
z=1~4(1=off,2=4k->1080p,3=hdbt mode, 4=Auto)
hdmi output 1 set to bypass
mode
19 / 24
