Climax VM1700S, Руководство по эксплуатации

Страница: 50 / 94

Page 38 VM1700S-1900S Operating Manual
Alternatively, the machine can be sent to CLIMAX for proper maintenance.
Under normal circumstances and proper handling the maintenance as described in
Table 5-1 is sufficient.
Under unfavourable circumstances, such as rough operation or operation under
harmful environmental conditions (high temperature, high humidity, etc.) the
inspection period should be shorter.
Table 5-1 lists maintenance intervals and tasks
5.2 L
UBRICATING THE MACHINE MODULES
Most of the machine components are maintenance-free.
The gear of the electric drive is lubricated for life-time, i.e. there is no need of
additional lubrication.
The gear of the pneumatic drive motor has to be disassembled and cleaned after
150 working hours and then be lubricated with Bosch-special grease. This proce-
dure has to be repeated every 300 working hours. This service is offered by CLI-
MAX.
The drive chain integrated in the machine arm and the upper gear has to be
inspected every 500 working hours (after 1 year at the latest). For this inspection,
the cover of the upper gear has to be removed and the gears as well as the chain
have to be thoroughly lubricated with Tunap Tunfluid HT 2200. After replacing
the cover, the drive chain tension has to be adjusted.
We recommend to have this service done by the manufacturer due to the experi-
ence required.
T
ABLE
5-1. M
AINTENANCE INTERVALS AND TASKS
Interval Task
Before each use
Lubricate ball joint coupling with Molykote or Unimoly G82
Check machine for visible damages
Check power supply lines for visible damages
Check maintenance unit (with pneumatic drive)
Check ventilating slots of electric drive motor
After 150 operating hours, for following
inspections every 300 operating hours
Clamping and lubrication of pneumatic drive gear
Every 500 operating hours or every year
Lubrication of drive chain
Lubrication of upper gear