Climax FF7200, Руководство по эксплуатации

Страница: 31 / 146

P/N 59129, Rev. 9 Page 23
CAUTION
For precise machining and to avoid damage to the machine, the
counterweight and machining arm should always be equally spaced
from the center of the machine. The location numbers should be the
same.
Chuck mounting
See the Installation Hazards section on page 15 for a full list of installation hazards.
The machine ships with the main body mounted to the chuck.
To prevent accidental machine rollout, tack weld safety blocks over the upper chuck arms
immediately after lifting the machine into place, before leveling or centering the machine.
Recommended ID mounting setup
Chucking leg chart
Diameters 10" (762 mm) leg 5" (127 mm) leg 2.5" (63.5 mm) leg
30
–
35" (762
–
889 mm) 0 0 0
35
–
40" (889
–
1,016 mm) 0 0 1
40
–
45" (1,016
–
1,143 mm) 0 1 0
45
–
50" (1,143
–
1,270 mm) 0 1 1
50
–
55" (1,270
–
1,397 mm) 1 0 0
55
–
60" (1,397
–
1,524 mm) 1 0 1
60
–
65" (1,524
–
1,651 mm) 1 1 0
65
–
70" (1,651
–
1,778 mm) 1 1 1
Do the following to mount and align the machine:
1. Measure the bore diameter of the work piece.
2. Select the proper leg extensions and screw actuators.
3. Apply never-seize (provided in the tool kit) to the threads and contacting faces of each leg
section before screwing them together.
Figure 12. Anti-seize lubricant locations