Climax CM6200, Руководство по эксплуатации

Страница: 120 / 334

Recommended lubricants
Page 102 CM6200 Operating Manual
6. Check the tension of the hub without the drag brake using a torque wrench
in the gear keyway, it should read approximately 4 in-lbs (0.452 Nm) with-
out the drag brake engaged.
7. Rotating the machine manually in the horizontal position should show
around 4 in-lbs of torque without the drag brake engaged. This is measured
at the motor gear using a torque wrench in the gear keyway.
8. Tighten the lock nuts on top of the drag brake to lock the drag brake in
position, and to keep the lock nuts from vibrating loose.
9. Install the motor for your machining application.
5.3 R
ECOMMENDED LUBRICANTS
CLIMAX recommends using the following lubricants for maintaining the loca-
tions indicated. Failure to use the appropriate lubricants can result in damage and
premature machine wear.
CAUTION
Avoid damage, premature machine wear, and protect your warranty by
using only approved lubricants.
T
ABLE
5-2. A
PPROVED LUBRICANTS
Application Area Lubricant
Biodegradable
Lubricant
Viscosity
(cSt)
Quantity Frequency
Frequently
Cutting Tool AW 32
CONOCO Eco-
terra 32
32 @ 40C
544 @ 100C
As required
Continued use while
cutting
Daily
Milling Head
Gearbox
Mobilith SHC 460 N/A
414 @ 40C
47 @ 100C
5 cc
Every 8 hours of
use
Dovetail Ways
a
AW 32
CONOCO Eco-
terra 32
32 @ 40C
544 @ 100C
As required
Daily during
machine use
Unpainted Sur-
faces
LPS1 or LPS2 N/A 38 @ 25C As required
Daily during
machine use, and
before storage
Each Use
Hydraulic Power
Units
CASTROL Hyspin
AWS-46 (summer) CASTROL BioBar
46 (summer); 32
(winter)
46 @ 40C
682 @ 100C
As required to
fill reservoir to
mid-sight
glass level
Refill every use
Replace oil every 2
years
b
AWS-32 (winter)
32 @ 40C
544 @ 100C