Compatible with Control4
AMP
L
R
GND
Zone 4
AMP
L
R
GND
Zone 3
L
R
GND
Zone 1
L
R
GND
Zone 2
Input 1
Input 2
Audio Out
Audio Out
Compatible with Control4
L
R
GND
Zone 4
L
R
GND
Zone 3
L
R
GND
Zone 1
L
R
GND
Zone 2
AMP
Input 1
Input 2
AMP
AMP
Audio Out
Audio Out
AMP
5
7
6
8
Follow this wiring for direct or network use of module.
From: Previous Module
Based on following wiring diagram, it would be possible to control volume of each zone by
controlling its relevant amplifier.
It is recommended to use short length shielded cable for input connec ons.
The amplifier you select for your project must be powerful enough to support 4 audio zone.
Use the following wiring diagram, if you don’t need to control volume of each zone separately.
Use the terminator socket for the last module in C-Bus network.
Before wiring the device, always unplug the main power.
Module’s LEDs
Power:
When the module is connected to main power, “Power LED” will flash smoothly.
Status:
When the module is connected to C-Bus network and receives valid data packets, “Status
LED” flashes quickly. “Status LED” is “off” when the module doesn’t receive any data. In direct
mode, “Status LED” will flash once when the module receives a valid data packet from Home
Controller.
When the module is receiving invalid data packet ,”Status LED” will remain “on” for 5 seconds.
In some cases, when a new module is added to C-Bus network, “Status LED” might remain “on”
for 5 seconds. This situa on must not be considered as an error.
Out1 to Out4:
Shows connec on status of module’s audio inputs/outputs. Also when the module is
connected to main power, The channel LEDs will display the module address in binary for 2
seconds.
To: Next Module
