2
Alarm Silence
Press the Function button once to enter Alarm Silence mode for 10 minutes while alarming.
Under Alarm Silence mode, the Water Sensor will not sound alarm. The LED Indicator will flash
every second to indicate it is under Alarm Silence mode.
After 10 minutes, if water still persists, the Water Sensor will raise alarm and send alarm signal
again.
Battery and Low Battery Detection
The Water Sensor uses one CR123 3V Lithium battery as its power source.
The Water Sensor features Low Battery Detection function. When the battery voltage is low, the
Water Sensor will transmit Low Battery signal to the Control Panel.
When under Low Battery status, the LED will flash every 4 seconds to remind the user to insert a
new battery.
The Low Battery signal will not disappear until a new battery is inserted.
When changing battery, after removing the old battery, press the Function Button twice to fully
discharge before inserting a new battery.
Supervision
The Water Sensor will transmit a supervision signal to report its condition regularly according to
user setting. The factory default interval is 30 minutes. The user can also press the Function
Button once to transmit a supervision signal manually.
Getting Started
Remove the battery insulator to power on the Water Sensor.
Put your Control Panel into learning mode (Please refer to your Control Panel manual for details).
Press the Learn/Test button once to transmit a learn code to the Control Panel, the LED will flash 3
times to indicate.
If the Control Panel receives the learn code, it will display the information accordingly, refer to the
Control Panel manual to complete the learning process. You can start Mounting process
Installation
Mounting
There are two ways to mount the Water Sensor:
Wall mounting (use the external water sensing probe):
1. Choose to install the Water Sensor at a desirable height
2. Drill hole in the surface.
3. Insert the screw into the hole.
4. Hook the Water Sensor onto the screw using the Mounting Hook behind the device.
5. The external water probe connector is pre-installed with a
plastic plug
(
Fig.1
), please remove it.
6. Connect the enclosed water sensing probe to the external water probe connector.
Ground surface mounting (use the built-in water sensing probes):
- Simply place your Water Sensor at the desirable location on the ground.
- Do NOT place on conductive surface.
Water Sensing Cable
A Water Sensing Cable or Water Probe Cable is available for selection. The cable can be further
extended by connecting to another cable to improve detection range.
Water Sensing Cable
(earphone jack type)
Water Probe Cable
(earphone jack type)
(
Fig 1
.)