Water Detection Probe
The Water Sensor is shipped with a factory supplied water detection probe. The probe may be further
extended by connecting other optional probes to improve detection rage.
Available option probe types include
A.
1 to 1 19cm probe.
B.
1 to 4 33cm probe.
C.
1 to 1 180 cm probe.
Multiple extension probes can be further interconnected according to user need. See pictures below for
some wiring samples.
NORMAL OPERATION:
When the probes come into contact with water, Water Sensor will transmit an alarm signal to the
Control Panel, and raise alarm with its built in buzzer.
Whenever the water level subsides, the Water Sensor will transmit an alarm restore signal and stop
the alarm.
You can silence the alarm by pressing the Learn/Test button once. The Water Sensor will silence the
buzzer and enter Sleep Mode until the water subsides. During the Sleep Mode, if the water condition
persists, the Water Sensor will no longer raise alarm. If you press the Learn/Test button under Sleep
Mode, the Water Sensor will emit a long beep to remind you the water has not subsided yet.
After the water has subsided and the probes are no longer in contact with water, the Water Sensor
will send a restore signal to the Control Panel to indicate the water condition has been restored. The
Water Sensor then returns to Normal Operation Mode.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
B
A
C