3
Press and hold the function button for 3 seconds, release the button when the Blue LED light on, the Blue LED
will light on for 25 seconds in learning mode, add PIR Camera into the Control Panel during this period (refer to
your Control Panel to finish learn in process). If the PIR is successfully added into the Control Panel, the Blue
LED will flash 6 times to indicate. If PIR is not added within 25 seconds, please repeat learning process.
<NOTE>
If the PIR Camera already exists in a Control Panel system, you will need to first remove the PIR Camera
from the Control Panel before you can learn it into a different Control Panel.
When learning the PIR Camera into a repeater/router, please press the function button once (instead of
pressing and holding it for 3 seconds) to send a learn code. (P5 models only)
Walk Test
After the PIR Camera is learnt-in, put the Control Panel into “
Walk Test
” mode, hold the PIR Camera in the
desired location, and press the Function Button to confirm this location is within signal range of the Control Panel,
refer to Control Panel manual to complete Walk Test.
When you are satisfied that the PIR Camera works in the chosen location, you can proceed to mounting.
Edit PIR Camera Operation Area
Follow instruction below to change PIR Camera Area in the Control Panel
1) Use the panel Edit Device function to change PIR Camera area setting.
2) Press and hold the Test button for 3 seconds on the PIR Camera to send a signal to the panel, and then
release the button when the LED lights up.
Proximity Detection
VST-892 has a digital proximity detector that can detect any masking (blocking) attempt by an intruder.
When a masking event is detected, and the masking condition lasts for 2 minutes, VST-892 will send tamper
open signal to the Control Panel to notify user of the condition.
After masking/blocking is removed for 2 minutes, VST-892 will send tamper restore signal to the Control Panel.
Pet Immunity Function
The PIR sensor supports pet immunity feature and will not detect pets up to 50 cm/20 kg to minimize false alarm
situation.
The Pet Immunity function can be enabled/disabled by setting the Jumper Switch (JP3) position. When the Jumper
Switch (JP3) is set to ON, Pet Immunity is disabled. When the Jumper Switch (JP3) is set to OFF, Pet Immunity is
enabled. (Factory default).
Sensitivity Increaser Function
You can use the sensitivity increaser function to increase the PIR’s detection sensitivity. To increase detection
sensitivity, set the Jumper Switch (JP4) to ON. To maintain normal detection sensitivity, set the the Jumper Switch
(JP4) to OFF (Factory default).
Installation
Installation Guideline
The PIR Camera is designed to be mounted on either a flat surface or in a corner situation with fixing screws and
plugs provided.
The base has knockouts, where the plastic is thinner, for mounting purpose. Two knockouts are for surface fixing
and a triangular mounting bracket is used for corner fixing.
The detection range is up to 10 meters if the PIR Camera is mounted 2.3-2.5 meters above ground.
When Pet-Immunity function is enabled, it will not detect pets up to 50cm/20kg when mounted at 2.3-2.5 meters
above ground. If required, you can adjust the height of the PIR Camera according to the size of your pet for
optimal pet immune performance. Higher installation location will provide larger pet-immune space, but also
increases the blind spot under the PIR Camera.
When VST-892 is mounted with rotating bracket, it will not have the regular detection area (as in the diagram), or
the typical pet immue range.
