1
PIR Motion Sensor IR-32 Series
Introduction
The PIR detects infrared signature to pick up movements within an assigned area and signals the Control Panel to activate the alarm if an
intruder crosses its’ path of detection.
The PIR is designed to give a typical detection range of 12 meters when mounted at 2.5 meters above ground. The PIR sensor also supports pet
immunity feature and will not detect pets of up to 25 kg to minimize false alarm situation.
Remote configuration is supported for the PIR motion sensor. Besides adjusting the Jumper Switches, users can also enable/disable pet
immunity function and adjust the sensitivity of the PIR from the Control Panel.
The PIR consists of a two-part design made up of a cover and a base. The cover contains all the electronics and optics and the base provides a
means of fixing.
The IR-32 Series PIR Sensor includes the following models:
IR-32
– PIR Motion Detector powered by two Alkaline batteries
IR-32SL
– PIR Motion Detector powered by one CR123 battery
Parts Identification
1. Test Button / LED Indicator
-
The test button is used for testing the radio performance and for learning purpose.
-
The LED indicator is used to indicate the status of system.
2. IR Sensor
3. Tamper Switch
4. Pet Immunity Enable/Disable Jumper Switch (JP3)
-
When set as ON, Pet Immunity is disabled.
-
When set as OFF, Pet Immunity is enabled. (Factory default)
5
.
Sensitivity Increaser Jumper Switch (JP4)
-
When set as ON, the PIR’s detection sensitivity is high.
-
When set as OFF, the PIR’s detection sensitivity is in normal level. (Factory default)
6. Bottom Fixing Screw
7. Battery Compartment
8. IR-32 Battery Insulator Hole
9. IR-32SL Battery Insulator Hole
Features
LED Indicator
In Normal operation mode, the LED Indicator will light up in the following situations:
When movement is detected under low battery condition
When the cover is opened and the tamper switch is triggered.
When movement is detected if the Tamper condition persists.
When movement is detected under Test mode
When the Test Button is pressed under tamper condition or if PIR is under low battery.
The LED will not flash if the PIR tamper and battery are normal and PIR is not under test mode.
Jumper On
The jumper link is inserted
connecting the two pins
Jumper Off
If the jumper link is removed or “
parked
”
on one pin.
