1
Acoustic Glass Break Detector (ACGS-23ZW)
The Glass Break Detector detects the high frequency sound emitted by glass breakage and transmits signal
to notify the alarm system control panel when it is triggered.
The Glass Break Detector is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network
and allows access to the “S2 Unauthenticated” class.
Z-Wave is a wireless communication protocol that uses a low-power RF radio. By taking advantage of the
Z-Wave mesh network, commands can be transmitted to their destination via intermediary “listening” Z-Wave
products.
Parts Identification
1. Green LED Indicator (Inside)
Flashes for 1 second: When Detector is powered on.
Slow Flashes: When the Detector is under Test Mode after Function Button pressed.
Quick Flash: When Detector is activated under Test mode.
Flashes once every 4 seconds: Battery is exhausted.
2. Red Indicator (Inside)
Flashes for 1 second: When Detector is powered on.
3. Microphone
4. Dip Switch
5. Battery Compartment
6. Function Button
-Press the button 3 times within 1 second to send a learn code.
-Press the button to send wakeup notification report.
-Press and hold the button for 10 seconds to perform factory reset.
7. Tamper Switch
-The tamper switch is compressed against the back cover and protects the Detector from cover
opening or removal from mounted location
8. Breakaway Area
The Breakaway Area has 2 knockouts where plastic is thinner for screw mounting. When the Detector
is forcibly removed from mounting location, the Break Away area will detach and allow tamper switch
to be activated.
Features
Battery
The Glass Break Detector uses a 3V CR123A Lithium battery.
The Glass Break Detector will report its battery percentage to the Control Panel respectively at 100%
(0x64), 75% (0x4B), 50% (0x32) and 25% (0x19). If the battery voltage is low (25%), a Low Battery
signal will be sent to the Control Panel to notify the user. When battery level is dead (cut off), the sensor
will send 0xFF to the Gateway/Control Panel.
The Glass Break Detector can detect low battery voltage. When low battery voltage is detected, a low
battery signal will be sent to the Control Panel along with regular signal transmissions for the Control
Panel to display the status accordingly.
