FACT™— False Alarm Control and Test
With FACT, you’ll never experience repeated false alarms. If your six-sound siren
goes off, DO NOT remotely disarm the system while the siren sounds; allow it to
run for the full siren duration. Before sounding the siren a second time, the system
automatically checks for another activated trigger. Should the siren sound again,
you will know for sure that someone is tampering with your vehicle. (To disable
FACT, see User-Selectable Features on pages 9-10.)
Dual-Mode Tampering Warning
Normally, the system immediately sounds its six-sound siren at the first inkling of
an intrusion attempt. However, you may set the system to issue a rapid five-chirp
warning whenever the system detects tampering to the exterior of your vehicle. If
there is any further tampering within the next 30 seconds, or if a door, the hood or
trunk is opened at any time, your system will sound a continuous 125dB
six-sound siren blast. To select the mode of your choice, see User-Selectable
Features on pages 9-10.
NOTE:Turning on the Tampering Warning feature overrides the FACT fea-
ture, and vice-versa.
Smart Prior Intrusion Attempt Alert
When you remotely disarm, if you hear 3 chirps instead of the usual one chirp it
means that a trigger or sensor was activated in your absence. When you enter the
vehicle, the LED will blink several times, pause, then repeat the blink cycle 4
more times. Count the number of blinks in one cycle and refer to the chart below:
Number of LED blinks per cycle after disarming
Trigger/Sensor Activated
1 blink
Magnetic Resonance Sensor
2 blinks
Door trigger
3 blinks
Trunk or hood trigger
AutoLock/AutoUnLock
For your safety and that of your passengers, the system automatically locks the doors
when you turn on the ignition switch to start the engine and unlocks them once the
ignition is turned off. If you prefer, you may turn off the AutoLock/AutoUnLock
feature. See the User-Selectable Features section on pages 9-10.
Siren Duration
When the system detects an intrusion attempt, the alarm is set to sound for 30
seconds. However, if you prefer, you may change it to 60 seconds. See the
User-Selectable Features section on pages 9-10.
7
Содержание XL2000
Страница 1: ......
