ADVANCED PROGRAMMING
Delete
A Remote Control channel programmed into a ClickOn
receiving device may be deleted from that device by
following the procedure below:
1. Place the receiving device into the programming mode.
This is normally done by pressing and holding the button
on the receiving device until the receiving device LED
starts flashing continuously. (See receiving device user
manual for more information).
2.
Press and hold the appropriate
button on the remote control until the
remote sounds 3 beeps followed
by another set of 4 beeps. Check
for a confirmation signal from the
receiving device. (See receiving
device user
manual for more
information).
3. Exit the programming mode on the receiving device.
Delete All
All remote control channels programmed into ANY ClickOn
RECEIVING device can be deleted entirely by using any
ClickOn Remote Control. The remote control used for this
need not be one that was previously programmed into the
device. This allows a lost or stolen remote control to be
deleted before reprogramming the new remote control.
1. Place the receiving device into the programming mode.
This is normally done by pressing and holding the button
on the receiving device until the receiving device LED
starts flashing continuously. (See receiving device user
manual for more information).
2.
Press and hold any button on the
remote control until the remote
sounds 3 beeps, then 4 beeps and
then 5 beeps (approximately 17
seconds). Check for a confirmation
signal from the receiving device.
(See receiving device user manual
for more information).
3. Exit the programming mode on the receiving device.
KEYPAD LOCK FUNCTION
The keypad lock function can be used to prevent accidental remote
control activation.
Enabling the Keypad Lock Function
Before the keypad lock function can be used, it has to be
enabled as follows:
Press and hold button 3 and 4 simultaneously until the
remote sounds a burst of beeps (after approximately 5
seconds).
The keypad can now be locked and unlocked (see
Locking/Unlocking the Keypad)
Disabling the Keypad Lock Function
Press and hold button 3 and 4 simultaneously until the
remote sounds a short beep (after approximately 5 seconds).
The keypad lock function is now disabled.
Locking/Unlocking the Keypad
Lock or Unlock the Keypad on the Remote Control by
pressing buttons 3 and 4 simultaneously. The Remote
Control will sound a long beep when the Keypad is locked
and any key is pressed on the remote control.
BATTERY REPLACEMENT
If the remote control does not respond to any key presses or
the LED fails to come on when a key is held in, the battery
may need replacement.
The remote control uses one type 23A 12V battery.
WARRANTY
The manufacturer warrants that the product identified in this manual is free
from defects in material or workmanship. This warranty is valid for a period
of 12 months from date of purchase. The manufacturer, at its discretion, will
repair or replace the defective product when returned to the manufacturer
via the retailer of the system. In the event that no satisfaction can be
obtained from the retailer of the system, only then can the manufacturer be
approached directly by the final purchaser. The manufacturer shall not be
responsible for any loss or damage of any nature whatsoever whether direct
or indirect, consequential or otherwise, sustained as a result of the use of
the product. Improper use or mishandling of this product by the purchaser
will render this warranty null and void. No warranty claims will be entertained
without presentation of a valid invoice. The manufacturer will charge the
purchaser for services rendered outside the warranty period. Any implied
warranties in respect of this product are expressly excluded. No agreement
whether implied or referred are binding, unless agreed to in writing by the
manufacturer.
CL-KEY-06-R4.2 MAR 2006 © ClickOn Technology (Pty) Ltd
