Click RevoFit2, Руководство пользователя

Страница: 6 / 8

Note of location of
the inner for the
future pilot hole
Lamination Instructions Continued:
Cut out the panels:
9
Sand edges
Clear tube holes
Prepare housing:
10
Finish sanding exit
holes by hand until extra smooth
1. Trim tube ends
to edge of housing
2. Clear all debris
Grind fl ush with top of reel housing.
Take care to not damage reel housing.
Use small end of blade for round corners
Scalloped blade
Drill pilot hole to access tab for reel removal: 11
Locate inner for
pilot hole.
Drill through
lamination at an
angle creating a
tunnel to access the
pilot hole & release
tab (2mm drill bit).
Test and clear hole
before installing
dial.
Fabricate and install pads:
12
Pad thickness, material and shape
are used to re fi ne pressure and fi t.
Pad Material: Pads should be
dense enough to create pressure
and not compress under tension.
Pad Thickness: Average 3/16”
(4.75mm) Push shore: 35
Slight convex
shape allows
for better
application of
pressure.
Convex pad
Skive edges
Panel
INCORRECT - Pad too thin when panel is fl ush with socket
CORRECT - Pad is the correct thickness when panel sits above socket when fi t is snug to patient
Good Closure Force
Weak Closure Force
5-10mm
Frame
Critical distance
Pad
Panel
Frame
Pad
Panel